Ultra Micro J-3 Cub
from Parkzone
Micro Electric model RTF or BNF versions
Coming soon

Parkzone continue to expand their range of scale indoor electric flyers with this delightful ready to fly Piper J3 Cub.

The all foam ready to fly one-piece model features an under cambered wing section designed to allow the model to be flown slowly and an upper wing surface with moulded in wing ribs and doped fabric effect finish for a more scale like appearance.

The engine cowling is complete with dummy Lycoming engine cylinders whilst the lower fuselage has a convenient moulded battery placement “pocket”. The model is finished in a scale Piper yellow colour scheme with black accents, registration numbers and of course the Piper Teddy Bear logo on the tail-fin.

On board the 2.4 GHz fully proportional three channel electronics controlling throttle, elevator and rudder are pre-installed with sprung carbon pushrods to the rudder and elevator. The steerable tail wheel and scale looking sprung wire landing gear comes complete with lightweight foam Cub “doughnut” wheels, enabling the model to take off and land on smooth surfaces.

This one box purchase comes complete with everything included, a 2.4Ghz transmitter, 1S 3.7volt 120 mAh Li-Po battery and Li-Po balancing charger powered by 4 AA dry batteries. With no further building or additional purchases needed this super little model can be in the air in no time at all.

Designed primarily for indoor flight and weighing in at a mere 25 grams this super model is sure to delight indoor pilots with its scale like flying characteristics and good looks and there is no doubt that this great little model could also be flown outdoors in very calm conditions when there is little or no wind.

Wingspan      460 mm (18.2")
Length     314 mm (12.4")
Weight     24 g (.85 oz)
Receiver:     PKZ 3 channel 2.4GHz DSM 2 RX/ESC unit
Battery     3.7V 120mAh LiPO
Charger     DC single cell fast charger

    * Three-channel control (rudder/elevator/throttle) that’s perfect for intermediate pilots
    * Difficult to damage and easy to repair thanks to highly durable EPS foam
    * Lightweight at only 24 grams
    * Lots of power through lightweight 3.7V Li-Po battery
    * No worries about interference because of DSM2 radio architecture
    * Ready-To-Fly version includes everything needed to fly in one box, with no additional completion necessary
    * Quick and safe battery charging courtesy of DC Li-Po charger


Included
Transmitter
Transmitter batteries
12v Charger
Flight battery

BNF version
If you already have either a Spektrum™ or JR® 2.4 GHz radio the the Bind-N-Fly version of the J-3 Cub offers you a more economical alternative, and the trouble of storing another radio!
As with the RTF version the BNF J-3 cub is fully assembled ready to go (well, you have to plug the undercarriage in) and comes complete with a battery and a charger.
Once the battery is charged bind the plane to your radio and you’re all ready to go!

To see the model flying follow this link