Multiplex Combo HFMx M-LINK with RX-5 light M-LINK
from Multiplex
Converts your Multiplex Radio from 35mhz to 2.4Ghz

HFMx M-LINK 2.4 GHz RF module
If you frequently switch between 35 / 40 ... MHz and 2.4 GHz with the same transmitter, or wish to use an earlier transmitter on the 2.4 GHz band, then the HFMx M-LINK external module is the right solution for you.
The module simply plugs into the transmitter’s Trainer socket, and can either be fixed to the transmitter itself or installed in a transmitter tray. No modifications of any kind are required to the transmitter, and the conversion takes just a few moments to complete. The change-over switch on the HFMx M-LINK module provides a convenient means of switching between the different frequency bands - e.g. 35 MHz and 2.4 GHz - at any time.

The plus-points:
• Fast, simple, change-over from 35, 40 ... MHz to 2.4 GHz operation using the switch mounted directly on the HFMx module
• Change-over switch for selecting normal or restricted frequency band (“France mode”)
• Change-over switch for selecting 14 ms (Fast Response) or 21 ms servo frame rate
• Activating button on the module itself for selecting binding mode and range check mode
• LED status indicator

The HFMx M-LINK 2.4 GHz module can be used with the following transmitters:

• Cockpit MM   • Cockpit SX   • Combi 80 / sport / plus   • Combi 90   • Cockpit   • Commander   • Commander mc 2010 / 2015 / 2020   • EUROPA SPRINT   • EUROPA SPORT   • EUROPA mc 1005 / 1010 / 1020   • PiCOline    • PROFI mc 3010 / 3030 / 4000    • ROYAL mc    • ROYALevo 7, 9, 1   • ROYALpro 7, 9, 12

Specification:
Frequency range 2.4000 GHz … 2.4835 GHz
Limited frequency range 2.4000 GHz … 2.4540 GHz
Transmission type 2.4 GHz FHSS M-LINK System
MULTIPLEX-LINK Frequency Hopping Spread Spectrum
Transmitter output 100 mW EIRP
Current drain approx. 50 mA
Temperature range -15°C … +55°C
Dimensions (L x W x H) approx. 83 x 52 x 11 mm (case)
Weight approx. 65 g


RX-5 light M-LINK 2.4 GHz receiver
Small, reasonably priced five-channel 2.4 GHz M-LINK receiver with the UNI connector system. A compact case and small dimensions in conjunction with in-line connectors make this unit ideal for the smaller model.
Typical applications:
• Model helicopters up to around 80 cm rotor diameter
• Electric and power models up to about 1.3 m wingspan
• Gliders and electric gliders up to about 2 m wingspan
• RC model cars
• RC model boats

The plus-points:
• HOLD / FAIL-SAFE function
• Integral button and LED for:   Binding - FAIL-SAFE programming - RESET - Operating status information

Specification:
Servo channel count   -  Reception system 2.4 GHz FHSS (Frequency Hopping Spread Spectrum)  -  Operating voltage 3.5 … 9.0 V  -  Power supply 4 - 5 NiXX cells, 2S LiPo / LiIo  -  Operating temperature range -20°C … +55°C  -  Dimensions (L x W x H) approx. 34 x 19.5 x 11 mm  -  Weight approx. 7 g